Portable power stantion repair

Repair Jackery, BLUETTI, EcoFlow, FlashFish, WellCharger, Anker, Xtorm, Netsodis, Revolt, Allpowers, Energizer, DEDRA, TIG FOX, BRIDNA, Akyga, Lipower, BlitzWolf, PowerPlant, Choetech, Newell, Genergy, VigorPool, Goal Zero, Voltronic

The battery of the charging station discharges too quickly

1. Check the presence of external powerful electrical devices connected to the charging station. If the power of the connected electrical appliance is approximately equal to the capacity of the station's battery, the battery will discharge in about 1 hour.
2. Perform a full charge and discharge to calibrate the charging station battery.

Unable to fully charge to 100%

• Calibrate the station battery by performing three full charges and discharges.

The portable charging station automatically turns off

1. When the battery of the charging station needs recharging.
2. If there is no consumption for a long time, the station is automatically turned off.
3. Check the settings or the manufacturer's instructions for the waiting time.
4. There are problems at the component level, due to which the station automatically shuts down.
5. Overheating of the system board of the charging station, battery or other components.
6. Failures are caused by improper operation of the firmware, components.

The portable charging station does not work or does not turn on

1. Check if it is caused by low battery. If so, charge and turn on the charging station again. If charging fails, follow charging failure instructions and manufacturer's recommendations.
2. If there is no response after a short or long press of the main power button, contact the manufacturer's support or our after-warranty service center.

AC (220V AC) or DC (12V,5V DC) output overload

1. Check whether the power of the connected device corresponds to the power range of the charging station.
2. The power of the electrical equipment is too large, because of which it does not work.
3. The DC/car charger output is overloaded. Make sure the rated current of the device is less than 8A. If the current is higher, it will cause overload and the charger may overheat.
4. The DC-USB-Type C output is overloaded. Check that the electrical equipment meets the limits of the charging station.

If you have problems with the charging station - contact our service centers in Kyiv! Call the phones specified in the " Contacts " section or write to Telegram @TGC_UA (0963114411)